Dot1X Tx-Period - Dell C9000 Series Reference Manual

Parameters
seconds
Defaults 30 seconds
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
7.6.1.0
7.4.1.0

dot1x tx-period

Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
C9000 Series
Syntax
dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
seconds
Defaults 30 seconds
Enter a time-out value in seconds. The range is from 1 to 300,
where 300 is implementation dependant. The default is 30.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Enter the interval time, in seconds, that EAPOL PDUs are
transmitted. The range is from 1 to 65535. The default is 30.
802.1X 260