Dot1X Supplicant-Timeout - Dell C9000 Series Reference Manual

authentication server for the supplicant MAC addresses configured in the associated
profile.
Before you enable static MAB, you must do the following:
Example
Dell(conf)#do show dot1x interface ten gigabit ethernet 0/41
802.1x information on Te 0/41:
----------------------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Critical VLAN:
Critical VLAN id:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Static-MAB:
Static-MAB Profile:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:

dot1x supplicant-timeout

Configure the amount of time after which exchanges with the supplicant time-out.
C9000 Series
Syntax
dot1x supplicant-timeout seconds
To return to the default, use the no dot1x supplicant-timeout command.
• Enable MAC authentication bypass on the port by configuring the dot1x mac-
auth-bypass command.
• Ensure that no configured profile exists at the time of configuring the static-
mab command.
• Use this command in Interface Batch Mode to enable static MAB in a dual-homing
setup.
Enable
AUTO
AUTHORIZED (STATIC-MAB)
Enable
400
Enable
400
Enable
400
3
Enable
400
Disable
Disable
Enable
Sample
30 seconds
60 seconds
2
30 seconds
30 seconds
60 seconds
2
SINGLE_HOST
Authenticated
Idle
802.1X 259