YOKOGAWA GX10 User Manual page 172

2.10 ASCII Output Format
2-154
Operation Event string
Module activation ApplyModule
Module update UpdateModule
Setting changes during recording
Alarm setting change SetAlarm
Alarm delay setting SetAlmDelay
change
Calibration SetCCModePnt
correction/set point
change
Calibration correction SetCCValue
value change
### information and detailed information
Unit00,Slot:01,2013/06/05,User01
—
Unit:uu,Slot:ss,mm•••,ii•••,vv•••
u Unit
s Slot
mm••• Module name
ii••• Serial number
vv••• Version number
cccc:l:(s,typ,val,hys,l,Otyp,Ono)=(b1,b2,b3,b4,b5,b
6,b7)->(a1,a2,a3,a4,a5,a6,a7)
c Channel
l Level
b1,•••,b7 Before change
a1,•••,a7 After change
The following settings (those that have
been changed among the following seven
settings)
s On/Off [ON, OFF]
typ Type [H,L,R,r,h,l,T,t]
val Alarm value
hys Hysteresis
l Logging [ON, OFF]
Otyp Output type [OFF,DO,SW]
Ono Output number
Example 1:
0001:1:(s,typ,val,hys,l,Otyp,Ono)=(off,TH
,off,-2.000,0.0005,DO,0001)->(off,TL,off,-
2.000,0.0005,SW,001)
Example 2:
0002:2:(val)=(-2.000)->(-1.000)
cccc:(hour,min,sec)=(b1,b2,b3)->(a1,a2,a3)
cccc Channel
b1,b2,b3 Before change
a1,a2,a3 After change
The following settings (those that have
been changed among the following three
settings)
hour Delay hour
min Delay minute
sec Delay second
Example:
A100:(hour,min,sec)=(00,00,00)->
(01,02,03)
cccc:(mode,num)=(b1,b2)->(a1,a2)
c Channel
b1,b2 Before change
a1,a After change
The following settings (those that have
been changed among the following two
settings)
mode Mode [OFF, Bias, Appro, Corr]
num Number of set points
Example:
0001:(mode,num)=(OFF,3)->(Appro,12)
cccc:pp:(input,output)=(b1,b2)->(a1,a2)
c Channel
p Set number
b1,b2 Before change
a1,a2 After change
IM 04L51B01-17EN