YOKOGAWA GX10 User Manual page 129

OCtrlTSP
Sets the Final Target Setpoint (/PG)
Sets the final target setpoint (TSP)
Syntax
OCtrlTSP,p1,p2
p1 Loop number
P2 Final target setpoint (PV range low limit to
PV range high limit)
Example Set the final target setpoint of unit 1, slot 5,
loop 2 to 2.5350.
OCtrlTSP,L152,2.5350
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
Operation is possible only when the program
operation is being held.
•
If p2 is set to a value outside the range or if the
program hold is released (program is running), E1 is
returned.
•
This operation is applied to the pattern number
specified with OCtrlPat.
•
When program operation is stopped, E1 is returned.
OCtrlRTIME
Sets the Segment Remaining Time (/PG)
Sets the remaining segment time
Syntax
OCtrlRTIME,p1,p2,p3
p1 Hour (0 to 99)
P2 Minute (0 to 59)
p3 Second (0 to 59)
Example Set the remaining segment time to 11 hours 05
minutes 22 seconds.
OCtrlRTIME,11,05,22
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
Operation is possible only when the program
operation is being held.
•
if the program hold is released (program is running),
E1 is returned.
•
This operation is applied to the pattern number
specified with OCtrlPat.
•
When program operation is stopped, E1 is returned.
IM 04L51B01-17EN
OCtrlStSeg
Sets the Start Segment Number (/PG)
Sets the start segment of program operation
Syntax
OCtrlStSeg, p1, p2
p1 Pattern number (1 to 99)
P2 Segment number (1 to the number of
segments in use)
Query
OCtrlStSeg[,p1]?
Example Set the start segment of program pattern
number 2 to 3.
OCtrlStSeg,2,3
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
E1 is returned in the following cases.
Program pattern with the number specified by p1 is
running.
Program pattern file for the number specified by p1
cannot be found.
The segment number specified by p2 is greater than
the number of segments in use.
•
When the program is reset, the start number returns to
segment number 1.
OCtrlDlyTime
Sets the Starting Time of Program
Operation (/PG)
Sets the delay time between the start of program
operation to when the program pattern operation actually
starts.
Syntax
OCtrlDlyTime,p1,p2,p3,p4
p1 Pattern number (1 to 99)
P2 Hour (0 to 99)
p3 Minute (0 to 59)
p4 Second (0 to 59)
Query
OCtrlDlyTime[,p1]?
Example Set the operation start delay time of program
pattern number 2 to 5 minutes 55 seconds.
OCtrlDlyTime,2,0,5,55
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
E1 is returned in the following cases.
Program pattern with the number specified by p1 is
running.
Program pattern file for the number specified by p1
cannot be found.
•
When the program is reset, the delay time is reset to
00:00:00.
2.6 Operation Commands
2-111
1
2
App