YOKOGAWA GX10 User Manual page 117

FCtrlNo
SP Number and PID Number Output
Outputs the SP number and PID number
Syntax
FCtrlNo,p1,p2
p1 First loop number
p2 Last loop number
Example Output the SP number and PID number of loop
number 001 currently in use.
FCtrlNo,L001
Description
•
If you omit p1 and p2, all loop numbers will be output.
•
If you omit p2, p2 is set to the same loop number as p1.
•
Only the information of detected modules will be
output.
•
For the output format, see
FCtrlMode
Control Mode Output
Outputs the control mode
Syntax
FCtrlMode,p1,p2
p1 First loop number
p2 Last loop number
Example Output the control mode of loop number 001.
FCtrlMode,L001
Description
•
If you omit p1 and p2, all loop numbers will be output.
•
If you omit p2, p2 is set to the same loop number as p1.
•
Only the information of detected modules will be
output.
•
For the output format, see
FPrgMode (/PG)
Program Operation Mode Output
Outputs the program operation mode
Syntax
FPrgMode,p1
p1 Program pattern number (1 to 99)
Example Output the program operation mode of
program pattern number 1.
FPrgMode,1
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
For the output format, see
FPrgPtnInfo (/PG)
Program Pattern Information Output
Outputs the program pattern status
Syntax
FPrgPtnInfo,p1
p1 Program pattern number (1 to 99)
Example Output the program operation mode of
program pattern number 1.
IM 04L51B01-17EN
page 2-164.
page 2-165.
page 2-166.
FPrgPtnInfo,1
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
During program operation, if the selected program
pattern is not being executed, an error occurs.
•
When program operation is stopped, the information at
the end of operation is output only when the selected
program pattern matches the program pattern that was
executed last.
•
For the output format, see
FPrgEvent (/PG)
PV Event and Time Event Information
Output
Outputs information about PV events and time events
occurring in the program pattern
Syntax
FPrgEvent,p1
p1 Program pattern number (1 to 99)
Example Output information about PV events and time
events of program pattern number 1.
FPrgEvent,1
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
When program operation is stopped, "0" is output for
PV events and time events.
•
For the output format, see
FPrgEnd (/PG)
Program Control End Signal Status
Output
Outputs the program control end signal status
Syntax
FPrgEnd,p1
p1 Program pattern number (1 to 99)
Example Output the program control end signal status of
program pattern number 1.
FPrgEnd,1
Description
•
This command is valid when the program control
function (/PG option) is in use.
•
This command can output the program control end
signal status for about 5 seconds after the program
operation ends normally.
•
The program control end signal is not output when the
operation is terminated by force (terminated through
reset).
•
When program operation is stopped, "0" is output.
•
For the output format, see
2.5 Output Commands
page 2-167.
page 2-168.
page 2-169.
2-99
1
2
App