YOKOGAWA GX10 User Manual page 122

2.6 Operation Commands
OMBRestore
Recovers Modbus manually
Resumes command transmission from Modbus client or
Modbus master to devices in which communication errors
have occurred.
Syntax
OMBRestore,p1
p1 Action type
0 Modbus client (Ethernet)
1 Modbus master (serial)
Example Manually recover the Modbus client.
OMBRestore,0
ORTReset
Resets a Relative Timer
Resets a relative timer.
Syntax
ORTReset,p1
p1 Timer type
0 All timers
1 to Timer number
Multiple selection is possible by
12
delimiting with colons.
Example Reset relative timer 2.
ORTReset,2
Reset relative timers 4, 9, and 12.
ORTReset,4:9:12
OMTReset
Resets the Match Time Timer
Resets the match time timer
Syntax
OMTReset,p1
p1 Timer type
0 All timers
1 to Timer number
Multiple selection is possible by
12
delimiting with colons.
Example Reset match time timer 2.
OMTReset,2
Reset match time timers 4, 9, and 12.
ORTReset, 4:9:12
OCmdRelay
Outputs the DO Channel and Internal
Switch Status
Outputs the DO channel and internal switch status.
Syntax
OCmdRelay,p1
p1 Specification of a setting
• Express the setting. Set a channel status
as follows: [channel number]-[status]. Use
a hyphen as a separator.
2-104
• You can specify the following values for
the channel number.
DO channel number
Internal switch number
• You can specify the following values for the
status.
Off: Off status
On: On status
• You can specify the status of multiple
channels at once. To do so, use a semicolon
to separate channels as follows: [channel
number]-[status]:[channel number]-
[status]:. . . You can specify up to a total of
32 channels that consist of DO channels
and internal switches.
Example Set channels 0101, 0102, and 0103 to On and
internal switches S001 and S002 to Off.
OCmdRelay,0101-On:0102-On:0103-
On:S001-Off:S002-Off
Description
•
If any of the channels that you specify do not exist or
are not set to manual output
the settings of all channels are canceled, and a
command error results.
OBatName
Sets a Batch Name
Sets a batch name.
Syntax
OBatName,p1
p1 Batch group number
When multi batch is disabled: Always 1
When multi batch is enabled: 1 to the
number used
p2 Batch number (up to 32 characters,
ASCII)
p3 Lot number (0 to 99999999, up to eight
digits, depending on Lot-No. digit)
Query
OBatName[,p1]?
Example Set the batch name structure to batch number
"PRESSLINE" and the lot number 007.
OBatName,1,'PRESSLINE',007
Description
•
For the characters that you can use in the specified
batch number (p2), see
•
The character limitations on the batch number (p2)
are the same as those for directory names. See the
SDirectory
explanation for the
•
You cannot set the batch number to a single space
character.
Doing so will clear the batch number.
(SRangeDO command),
Appendix 1.
command.
IM 04L51B01-17EN