Interfaces - Agilent Technologies G1367A Reference Manual

7
Theory of Operation

Interfaces

The Agilent 1100 Series modules provide the following interfaces:
Table 65 Agilent 1100 Series Interfaces
Interface Type Pumps
CAN Yes
GPIB Yes
RS-232C Yes
Remote Yes
Analog Yes
Interface Yes
board
* The well-plate sampler can be controlled through CAN via a detector that is connected via GPIB to a ChemStation.
† The vacuum degasser will have a special connector for specific use. For details see description of main board.
• CAN connectors as interface to other Agilent 1100 Series modules,
• GPIB connector as interface to the Agilent ChemStation,
• RS-232C as interface to a computer,
• REMOTE connector as interface to other Agilent products,
• Analog Output connector(s) for signal output, and
• Interface slot for specific interfacing (external contacts, BCD, LAN and so
For identification and location of the connectors
Never use cables other than the ones supplied by Agilent Technologies to ensure
WA RN ING
proper functionality and compliance with safety or EMC regulations.
228
Autosampler Well-plate
Sampler
Yes Yes
*
Yes No
Yes Yes
Yes Yes
No No
Yes Yes
on).
DA Detector VW Detector
MW RI Detector
Detector
FL Detector
Yes Yes
Yes Yes
Yes Yes
Yes Yes
2 × 1 ×
Yes Yes
Figure 5
1100 Series WS MWS Reference Manual
Thermostatted Vacuum
Column Degasse
Compartment r
Yes No
Yes No
Yes No
Yes Yes
†
No Yes
No No
on page 25.