Agilent Technologies G1367A Reference Manual page 25

14 Turn ON power by pushing the button at the lower left hand side of the
15 Close the front door. The exhaust fan will turn ON and remove the vapor
Vial number output
Control of
Thermostat
Figure 5
The sampler is turned ON when the line power switch is pressed and the green indicator
NO TE
lamp is illuminated. The detector is turned OFF when the line power switch is protruding
and the green light is OFF.
To disconnect the sampler from the line, unplug the power cord. The power will
WA RN ING
supply still uses some power, even switch at the front panel is turned OFF.
1100 Series WS MWS Reference Manual
sampler.
from the tray compartment. After 1-2 minutes the sampler will start the
hardware initialisation process. At the end of this process the status LED
should be green.
CAN cable to previous module
Cable Connections
CAN cable to next module
Installing the Sampler
1
25