8 Re-install the left side door (take care of the magnet at the back).
9 Place the sampler on top of the thermostat. Make sure that the sampler is
10 Remove the tray and the plastic cover from the tray base, place the air
Air channel adapter
Figure 7
11 Re-install the tray.
12 Ensure the power switch on the front of the sampler is 0FF and the power
13 Connect the cable between the well-plate sampler and the thermostat, see
Do not disconnect or reconnect the well-plate sampler to thermostat cable when the
WA RN ING
power cords are connected to either of the two modules. This will damage the
electronics of the modules.
1100 Series WS MWS Reference Manual
correctly engaged in the thermostat locks.
channel adapter into the sampler tray base. Make sure the adapter is fully
pressed down. This assures that the cold airstream from the thermostat is
correctly guided to the tray area of the well-plate sampler.
Installation of Thermostat and Sampler
cables are disconnected.
"Connection at the rear of thermostatted Sampler"
Installing the Sampler
on page 29.
1
27