Cisco Nexus 5600 Series Reference page 80

show ip pim oif-list
show ip pim oif-list
To display information about IPv4 Protocol Independent Multicast (PIM) interfaces for a group, use the
show ip pim oif-list command.
Syntax Description
group
source
vrf
vrf-name
all
default
management
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(3)N1(1)
4.1(3)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display IPv4 PIM interfaces for a group:
switch(config)# show ip pim oif-list 232.0.0.0
PIM OIF-List for VRF default
(*, 232.0.0.0/8)
Incoming interface: Null0, RPF nbr 0.0.0.0
Timeout interval: 66 secs left
Oif-list (count: 0):
Timeout-list (count: 0):
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
MCR-76
show ip pim oif-list group [source] [vrf {vrf-name | all | default | management}]
Group address.
(Optional) Source address.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies that all VRF entries be cleared from the IPv4 multicast routing table.
Specifies that the default VRF entry be cleared from the IPv4 multicast routing table.
Specifies that the management VRF entry be cleared from the IPv4 multicast routing
table.
Modification
This command was introduced.
Changed output to include vPC information.
Show Commands
OL-31626-01