Cisco Nexus 5600 Series Reference page 437

Chapter Show Commands
show ip pim rp
To display information about the rendezvous points (RPs) for IPv4 Protocol Independent Multicast
(PIM), use the show ip pim rp command.
Syntax Description
group
vrf
vrf-name
all
default
management
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about IPv4 PIM RPs:
switch(config)# show ip pim rp
PIM RP Status Information for VRF "default"
BSR disabled
Auto-RP disabled
BSR RP Candidate policy: None
BSR RP policy: None
Auto-RP Announce policy: None
Auto-RP Discovery policy: None
switch(config)#
OL-31626-01
show ip pim rp [group] [vrf {vrf-name | all | default | management}]
(Optional) Group address.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Specifies the default VRF.
Specifies the management VRF.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ip pim rp
433