Cisco Nexus 5600 Series Reference page 395

Chapter I Commands
ipv6 pim neighbor-policy
To configure a route-map policy that determines which IPv6 Protocol Independent Multicast (PIM6)
neighbors should become adjacent, use the ipv6 pim neighbor-policy command. To reset to the default,
use the no form of this command.
Syntax Description
policy-name
Defaults
Forms adjacency with all neighbors.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.0(3)N1(1)
Usage Guidelines
You can use the match ipv6 address command in a route-map policy to specify which groups to become
adjacent to.
This command requires the Enterprise Services license.
Examples
This example shows how to configure a policy that determines which PIM6 neighbors should become
adjacent:
switch(config)# interface ethernet 2/2
switch(config-if)# ipv6 pim neighbor-policy
This example shows how to reset to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ipv6 pim neighbor-policy
Related Commands Command
show ipv6 pim
interface
OL-31626-01
ipv6 pim neighbor-policy policy-name
no ipv6 pim neighbor-policy [policy-name]
Route-map policy name.
Modification
This command was introduced.
Description
Displays information about PIM6-enabled interfaces.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ipv6 pim neighbor-policy
391