Ip Pim Border - Cisco Nexus 5600 Series Reference

Chapter I Commands

ip pim border

To configure an interface on an IPv4 Protocol Independent Multicast (PIM) border, use the ip pim
border command. To remove an interface from a PIM border, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
The interface is not on a PIM border.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to configure an interface on a PIM border:
switch(config)# ip pim border
This example shows how to remove an interface from a PIM border:
switch(config)# no ip pim border
Related Commands Command
show ip pim interface
OL-31626-01
ip pim border
no ip pim border
Modification
This command was introduced.
Description
Displays information about PIM-enabled interfaces.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip pim border
323