Cisco Nexus 5600 Series Reference page 433

Chapter Show Commands
show ip pim policy statistics neighbor-policy
To display information about the neighbor policy statistics for IPv4 Protocol Independent Multicast
(PIM), use the show ip pim policy statistics neighbor-policy command.
Syntax Description
ethernet
slot/port
port-channel
number
sub_if-number
vethernet
veth-id
vlan vlan-id
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display information about IPv4 PIM policy statistics:
switch(config)# show ip pim policy statistics neighbor-policy ethernet 2/12
OL-31626-01
show ip pim policy statistics neighbor-policy {ethernet slot/port | port-channel
channel-number[.sub_if-number] | vethernet veth-id | vlan vlan-id}
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
(Optional) Subinterface number. The range is from 1 to 4093.
Specifies the virtual Ethernet interface. The range is from 1 to 1,048,575.
Specifies the VLAN. The range is from 1 to 4094.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ip pim policy statistics neighbor-policy
429