Cisco Nexus 5600 Series Reference page 225

Chapter Show Commands
show ip igmp snooping
To display information about IGMP snooping, use the show ip igmp snooping command.
Syntax Description
vlan vlan-id
Command Default
Displays all VLANs.
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display information about IGMP snooping for a VLAN:
switch(config)# show ip igmp snooping vlan 20
IGMP Snooping information for vlan 20
IGMP snooping enabled
Optimised Multicast Flood (OMF) disabled
IGMP querier none
Switch-querier disabled
IGMPv3 Explicit tracking enabled
IGMPv2 Fast leave disabled
IGMPv1/v2 Report suppression enabled
IGMPv3 Report suppression disabled
Link Local Groups suppression enabled
Router port detection using PIM Hellos, IGMP Queries
Number of router-ports: 1
Number of groups: 0
Active ports:
switch(config)#
OL-31626-01
show ip igmp snooping [vlan vlan-id]
(Optional) Specifies a VLAN. The range is from 1 to 3967 and 4048 to 4093. The
default is all VLANs.
Modification
This command was introduced.
Eth1/21 Po100
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ip igmp snooping
221