Cisco Nexus 5600 Series Reference page 163

Chapter I Commands
ip igmp querier-timeout
To configure a querier timeout that the software uses when deciding to take over as the querier, use the
ip igmp querier-timeout command. To reset to the querier timeout to the default, use the no form of
this command.
Syntax Description
timeout
Command Default
The querier timeout is 255 seconds.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
The ip igmp query-timeout command is an alternative form of this command.
This command does not require a license.
Examples
This example shows how to configure a querier timeout:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp querier-timeout 200
switch(config-if)#
This example shows how to reset a querier timeout to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp querier-timeout
switch(config-if)#
Related Commands Command
ip igmp query-timeout Configures a querier timeout.
show ip igmp interface Displays IGMP information about the interface.
OL-31626-01
ip igmp querier-timeout timeout
no ip igmp querier-timeout [timeout]
Timeout in seconds. The range is from 1 to 65,535. The default is 255.
Modification
This command was introduced.
Description
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip igmp querier-timeout
159