Chapter
I Commands
ip igmp snooping querier
To configure a snooping querier on an interface when you do not enable Protocol Independent Multicast
(PIM) because multicast traffic does not need to be routed, use the ip igmp snooping querier command.
To remove the snooping querier, use the no form of this command.
Syntax Description
querier
Command Default
None
Command Modes
VLAN configuration mode
Supported User Roles
network-admin
vdc-admin
Command History
Release
6.0(2)N1(1)
Usage Guidelines
The querier IP address cannot be a multicast address.
This command does not require a license.
Examples
This example shows how to configure a snooping querier:
switch(config)# vlan 1
switch(config-vlan)# ip igmp snooping querier 172.20.52.106
switch(config-vlan)#
This example shows how to disable IGMP snooping on a VLAN interface:
switch(config)# vlan 1
switch(config-vlan)# no ip igmp snooping querier
switch(config-vlan)#
Related Commands
Command
show ip igmp snooping Displays IGMP snooping information.
OL-31626-01
ip igmp snooping querier querier
no ip igmp snooping querier [querier]
Querier IP address.
Modification
This command was introduced.
Description
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip igmp snooping querier
213