Cisco Nexus 5600 Series Reference page 260

ip msdp sa-limit
ip msdp sa-limit
To configure a limit on the number of (S, G) entries accepted from the peer, use the ip msdp sa-limit
command. To remove the limit, use the no form of this command.
Syntax Description
peer-address
limit
Command Default
None
Command Modes
Global configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to configure a Source-Active (SA) limit for a peer:
switch(config)# ip msdp sa-limit 192.168.1.10 5000
This example shows how to reset the limit to the default:
switch(config)# no ip msdp sa-limit 192.168.1.10
Related Commands Command
show ip msdp peer
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
256
ip msdp sa-limit peer-address limit
no ip msdp sa-limit peer-address [limit]
IP address of an MSDP peer.
Number of (S, G) entries. The range is from 0 to 4294967295. The default is none.
Modification
This command was introduced.
Description
Displays information about MSDP peers.
Chapter I Commands
OL-31626-01