Cisco Nexus 5600 Series Reference page 445

Chapter Show Commands
show ipv6 mroute
To display information about IPv6 multicast routes, use the show ipv6 mroute command.
Syntax Description
group
source
summary
software-
forwarded
vrf
vrf-name
all
Defaults
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(3)N1(1)
Usage Guidelines
This command requires the Enterprise Services license.
Examples
This example shows how to display information about multicast routes:
switch(config)# show ipv6 mroute
IPv6 Multicast Routing Table for VRF "default"
(*, ff30::/32), uptime: 1d02h, pim6 ipv6
Incoming interface: Null, RPF nbr: 0::
Outgoing interface list: (count: 0)
switch(config)#
OL-31626-01
show ipv6 mroute {group | {source group} | {group [source]}} [summary [software-forwarded]]
[vrf {vrf-name | all}]
Group address for route.
Source address for route.
(Optional) Displays route counts and packet rates.
(Optional) Displays software-switched route counts only.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
show ipv6 mroute
441