Cisco Nexus 5600 Series Reference page 210

ip igmp snooping last-member-query-interval
ip igmp snooping last-member-query-interval
To configure a query interval in which the software removes a group, use the ip igmp snooping
last-member-query-interval command. To reset the query interval to the default, use the no form of
this command.
Syntax Description
interval
Command Default
The query interval is 1.
Command Modes
VLAN configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure a query interval in which the software removes a group:
switch(config)# vlan 1
switch(config-vlan)# ip igmp snooping last-member-query-interval 3
switch(config-vlan)#
This example shows how to reset a query interval to the default:
switch(config)# vlan 1
switch(config-vlan)# no ip igmp snooping last-member-query-interval
switch(config-vlan)#
Related Commands Command
show ip igmp snooping Displays IGMP snooping information.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
206
ip igmp snooping last-member-query-interval interval
no ip igmp snooping last-member-query-interval [interval]
Query interval in seconds. The range is from 1 to 25. The default is 1.
Modification
This command was introduced.
Description
Chapter I Commands
OL-31626-01