Cisco Nexus 5600 Series Reference page 347

Chapter I Commands
ip pim neighbor-policy
To configure a route-map policy that determines which IPv4 Protocol Independent Multicast (PIM)
neighbors should become adjacent, use the ip pim neighbor-policy command. To reset to the default,
use the no form of this command.
Syntax Description
policy-name
Command Default
Forms adjacency with all neighbors.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
You can use the match ip address command in a route-map policy to specify which groups to become
adjacent to.
This command requires the LAN Base Services license.
Examples
This example shows how to configure a policy that determines which PIM neighbors should become
adjacent:
switch(config)# interface ethernet 2/2
switch(config-if)# ip pim neighbor-policy
This example shows how to reset to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip pim neighbor-policy
Related Commands Command
show ip pim interface
OL-31626-01
ip pim neighbor-policy policy-name
no ip pim neighbor-policy [policy-name]
Route-map policy name.
Modification
This command was introduced.
Description
Displays information about PIM-enabled interfaces.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip pim neighbor-policy
343