Cisco Nexus 5600 Series Reference page 253

Chapter I Commands
ip msdp originator-id
To configure the IP address used in the RP field of a Source-Active message entry, use the ip msdp
originator-id command. To reset the value to the default, use the no form of this command.
Syntax Description
ethernet
slot/port
loopback
if_number
port-channel
number
vlan vlan-id
Command Default
The MSDP process uses the RP address of the local system.
Command Modes
Global configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
We recommend that you use a loopback interface for the RP address.
This command requires the LAN Base Services license.
Examples
This example shows how to configure the IP address used in the RP field of SA messages:
switch(config)# ip msdp originator-id loopback0
This example shows how to reset the RP address to the default:
switch(config)# no ip msdp originator-id loopback0
OL-31626-01
ip msdp originator-id {ethernet slot/port | loopback if_number | port-channel number | vlan
vlan-id}
no ip msdp originator-id [{ethernet slot/port | loopback if_number | port-channel number | vlan
vlan-id}]
Specifies the Ethernet interface and the slot number and port number. The slot
number is from 1 to 255, and the port number is from 1 to 128.
Specifies the loopback interface. The loopback interface number is from 0 to 1023.
Specifies the EtherChannel interface and EtherChannel number. The range is from 1
to 4096.
Specifies the VLAN interface. The range is from 1 to 4094.
Modification
This command was introduced.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip msdp originator-id
249