Cisco Nexus 5600 Series Reference page 416

show ip mroute summary
show ip mroute summary
To display summary information about IPv4 multicast routes, use the show ip mroute summary
command.
Syntax Description
count
software-
forwarded
vrf
vrf-name
all
group
Command Default
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to display summary information about IPv4 multicast routes:
switch(config)# show ip mroute summary
IP Multicast Routing Table for VRF "default"
Total number of routes: 1
Total number of (*,G) routes: 0
Total number of (S,G) routes: 0
Total number of (*,G-prefix) routes: 1
Group count: 0, rough average sources per group: 0.0
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
412
show ip mroute summary [count | software-forwarded] [vrf {vrf-name | all}]
show ip mroute [group] summary [software-forwarded] [vrf {vrf-name | all}]
(Optional) Displays only route counts.
(Optional) Displays software-switched route counts only.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
(Optional) Specifies a group address for a route.
Modification
This command was introduced.
Chapter Show Commands
OL-31626-01