Cisco Nexus 5600 Series Reference page 396

ipv6 pim register-policy
ipv6 pim register-policy
To filter IPv6 Protocol Independent Multicast (PIM6) Register messages that are based on a route-map
policy, use the ipv6 pim register-policy command. To disable message filtering, use the no form of this
command.
Syntax Description
policy-name
Defaults
Disabled
Command Modes
Global configuration mode
VRF configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
5.0(3)N1(1)
Usage Guidelines
You can use the match ipv6 multicast command in a route-map policy to specify the group or group and
source addresses whose register messages that should be filtered.
To display the configured register policy, use this command line:
switch(config)# show running-config | include register-policy
This command requires the Enterprise Services license.
Examples
This example shows how to filter PIM6 Register messages:
switch(config)# ipv6 pim register-policy my_register_policy
This example shows how to disable message filtering:
switch(config)# no ipv6 pim register-policy
Related Commands Command
show running-config
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
392
ipv6 pim register-policy policy-name
no ipv6 pim register-policy [policy-name]
Route-map policy name.
Modification
This command was introduced.
Description
Displays information about the running-system configuration.
Chapter I Commands
OL-31626-01