Cisco Nexus 5600 Series Reference page 174

ip igmp startup-query-interval
ip igmp startup-query-interval
To configure the query interval used when the IGMP process starts up, use the ip igmp
startup-query-interval command. To reset the query interval to the default, use the no form of this
command.
Syntax Description
interval
Command Default
The query interval is 31 seconds.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure a startup query interval:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp startup-query-interval 25
switch(config-if)#
This example shows how to reset a startup query interval to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp startup-query-interval
switch(config-if)#
Related Commands Command
show ip igmp interface Displays IGMP information about the interface.
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
170
ip igmp startup-query-interval interval
no ip igmp startup-query-interval [interval]
Query interval in seconds. The range is from 1 to 18,000. The default is 31.
Modification
This command was introduced.
Description
Chapter I Commands
OL-31626-01