Cisco Nexus 5600 Series Reference page 374

ip routing multicast software-replicate
ip routing multicast software-replicate
To enable software replication of IPv4 Protocol Independent Multicast (PIM) Any Source Multicast
(ASM) packets that are leaked to the software for state creation, use the ip routing multicast
software-replicate command. To reset to the default, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
No software replication.
Command Modes
Global configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
By default, these packets are used by the software only for (S,G) state creation and then dropped.
This command does not require a license.
Examples
This example shows how to enable software replication of IPv4 PIM ASM packets:
switch(config)# ip routing multicast software-replicate
switch(config)#
Related Commands Command
show running-config
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
370
ip routing multicast software-replicate
no ip routing multicast software-replicate
Modification
This command was introduced.
Description
Displays information about the running-system configuration.
Chapter I Commands
OL-31626-01