Cisco Nexus 5600 Series Reference page 173

Chapter I Commands
ip igmp startup-query-count
To configure the query count used when the IGMP process starts up, use the ip igmp
startup-query-count command. To reset the query count to the default, use the no form of this
command.
Syntax Description
count
Command Default
The query count is 2.
Command Modes
Interface configuration mode
Supported User Roles
network-admin
vdc-admin
Command History Release
6.0(2)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure a query count:
switch(config)# interface ethernet 2/2
switch(config-if)# ip igmp startup-query-count 3
switch(config-if)#
This example shows how to reset a query count to the default:
switch(config)# interface ethernet 2/2
switch(config-if)# no ip igmp startup-query-count
switch(config-if)#
Related Commands Command
show ip igmp interface Displays IGMP information about the interface.
OL-31626-01
ip igmp startup-query-count count
no ip igmp startup-query-count [count]
Query count. The range is from 1 to 10. The default is 2.
Modification
This command was introduced.
Description
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
ip igmp startup-query-count
169