Cisco Nexus 5600 Series Reference page 110

show ipv6 pim neighbor
show ipv6 pim neighbor
To display information about IPv6 Protocol Independent Multicast (PIM6) neighbors, use the show ipv6
pim neighbor command.
Syntax Description
if-type
if-number
neighbor-addr
vrf
vrf-name
all
Defaults
None
Command Modes
Any command mode
Supported User Roles
network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(3)N1(1)
Usage Guidelines
This command requires the Enterprise Services license.
Examples
This example shows how to display information about PIM6 neighbors:
switch(config)# show ipv6 pim neighbor
PIM6 Neighbor Status for VRF "default"
Neighbor Address
fe80::0230:48ff:fe34:0d67
Secondary addresses:
switch(config)#
Cisco Nexus 5600 Series NX-OS Multicast Routing Command Reference
MCR-106
show ipv6 pim neighbor {[if-type if-number] | [neighbor-addr]} [vrf {vrf-name | all}]
(Optional) Interface type. For more information, use the question mark (?) online
help function.
(Optional) Interface or subinterface number. For more information about the
numbering syntax for your networking device, use the question mark (?) online help
function.
(Optional) IPv6 address of a neighbor.
(Optional) Applies to a virtual routing and forwarding (VRF) instance.
VRF name. The name can be a maximum of 32 alphanumeric characters and is case
sensitive.
Specifies all VRFs.
Modification
This command was introduced.
0001::0002
Interface Uptime
Eth2/1 00:00:39
Show Commands
Expires DR Bidir
Pri
00:01:34 1 yes
OL-31626-01