Garmin G1000 NXi Pilot's Manual page 61

Black reference bugs with cyan letters appear along the right side of the airspeed scale denote GLIDE, V
and V . The pilot can enable/disable the display of these bugs, as well as change their values. When the
Y
indicated airspeed is below 20 knots, enabled Vspeeds Reference Bugs and their numeric values appear in a list
at the bottom of the airspeed tape, ordered from highest to lowest.
Enabling/disabling or modifying individual Vspeed Reference Bugs:
1) Press the Tmr/Ref Softkey.
2) Turn the large FMS Knob to highlight the desired Vspeed value.
3) Use the small FMS Knob to change the Vspeed in 1-kt increments (when a speed has been changed from a
default value, an asterisk appears next to the speed).
4) Press the ENT Key or turn the large FMS Knob to highlight the On/Off field
5) Turn the small FMS Knob clockwise to On or counterclockwise to Off.
6) To remove the window, press the CLR Key or the Tmr/Ref Softkey.
The pilot can also enable/disable all Vspeed Reference Bugs as a group.
Enabling/disabling Vspeed Reference Bugs as a group or restoring all default settings:
1) Press the Tmr/Ref Softkey.
2) Press the MENU Key.
3) Turn the FMS Knob to scroll as needed to highlight 'All References On', 'All References Off' or 'Restore Defaults'.
4) Press the ENT Key.
5) To remove the References Window, press the CLR Key or the Tmr/Ref Softkey.
190-02177-00 Rev. A
Figure 2-5 VSpeed References
References Window
Figure 2-6 References Window and Menu
Garmin G1000 NXi Pilot's Guide for the Cessna Nav III
FLIGHT INSTRUMENTS
Vspeed Bug
GLIDE G
V R
R
V X
x
V Y
y
Table 2-1 Vspeed Bug Labels
References Window Menu
V ,
R, X
47