Garmin G1000 NXi Pilot's Manual page 39

MFD SOFTKEYS
The MFD softkeys provide control over flight management functions, including GPS, NAV, terrain, traffic,
and weather (optional). There are many softkey functions available on the MFD depending on the page group
and screen selected.
The following table provides an example of the MFD Softkey functions accessed from the Navigation Map
screen. Further information concerning softkeys providing more navigation and flight planning functions
may be found in the Flight Management Section. Terrain, traffic, and weather softkey descriptions may
be found in the Hazard Avoidance section. Further description of optional equipment and corresponding
softkey functions may be found in the Additional Features Section.
Level 1 Level 2
Engine
Engine
Lean
System
Map Opt
Traffic
Inset
190-02177-00 Rev. A
Level 3 Description
Displays EIS - Engine Page and second-level engine softkeys; select again to
exit page (see the EIS Section for more information).
Displays second-level softkeys for additional EIS configuration.
Displays default EIS display.
CYL SLCT
Displays EIS lean display.
Assist
Allows selection of engine cylinder to view additional information.
Enables/disables leaning assist mode.
RST Fuel
Resets calculated fuel remaining to default and resets fuel used to zero.
GAL REM
Press to display the fuel totalizer softkeys
-10 GAL
Press to decrease remaining fuel quantity in 10-gallon increments.
-1 GAL
Press to decrease remaining fuel quantity in 1-gallon increments.
+1 GAL Press to increase remaining fuel quantity in 1-gallon increments.
+10 GAL
Press to increase remaining fuel quantity in 10-gallon increments.
35 GAL
Sets remaining fuel to 35 gallons.
53 GAL
Sets remaining fuel to 53 gallons.
Displays system oil pressure and temperature, fuel calculations, and
electrical system information.
Displays traffic information on Navigation Map Page.
Displays inset window second level softkeys.
Off
Removes VSD inset from Navigation Map Page.
VSD Displays VSD profile information of terrain/obstacles along the current track,
vertical track vector, and selected altitude.
Auto: Automatically displays either VSD profile information for
active flight plan information or along current track with no
active flight plan.
FPL: Displays VSD profile information for active flight plan.
TRK: Displays VSD profile information along current track.
Garmin G1000 NXi Pilot's Guide for Cessna Nav III
SYSTEM OVERVIEW
25