Garmin G1000 NXi Pilot's Manual page 448

APPENDIX B
Figure B-1 Database Page before Activation of Standby Databases
9) Verify the correct database cycle information is shown in the Standby Database column.
The Restart Softkey is enabled only when the aircraft is on the ground.
NOTE:
10) Press the Restart Softkey. A 10 second restart countdown will appear.
11) Press the Restart Button in the display window to continue with the restart of the system, or remove power
from the system if the Restart Softkey is diminished.
Figure B-2 Database Restart
12) Remove the SD card from the bottom slot of the MFD.
13) After restarting the system, turn the large FMS Knob and select the Aux page group on the MFD.
14) Turn the small FMS Knob and select the Databases page.
15) Verify that the standby databases transferred and are now in the active database column.
434 Garmin G1000 NXi Pilot's Guide for the Cessna Nav III 190-02177-00 Rev. A