Garmin G1000 NXi Pilot's Manual page 163

Selecting an airport for review by identifier, facility name, or location:
1) From the Airport Information Page, press the FMS Knob.
2) Use the FMS Knobs and enter an identifier, facility name, or location.
3) Press the ENT Key.
4) Press the FMS Knob to remove the cursor.
Selecting a runway:
1) With the Airport Information Page 1 displayed, press the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to place the cursor in the 'Runways' Box, on the runway designator.
3) Turn the small FMS Knob to display the desired runway (if more than one) for the selected airport.
4) To remove the flashing cursor, press the FMS Knob.
Viewing a destination airport:
From the Airport Information Page press the MENU Key. Select 'View Destination Airport'. The Destination
Airport is displayed.
The Airport Frequencies Box uses the descriptions and abbreviations listed in the following table:
A departure, arrival, or approach can be loaded using the softkeys on the Airport Information Page. See the
Procedures section for details. METARs or TAFs applicable to the selected airport can be selected for display (see
the Hazard Avoidance section for details about weather).
190-02177-00 Rev. A
Communication Frequencies
Approach * Control
Arrival * CTA *
ASOS Departure *
ATIS Gate
AWOS Ground
Center Helicopter
Class B * Multicom
Class C * Other
Clearance
* May include Additional Information
Table 5-6 Airport Frequency Abbreviations
Garmin G1000 NXi Pilot's Guide for Cessna Nav III
Navigation Frequencies
Pre-Taxi ILS
Radar LOC
Ramp
Terminal *
TMA *
Tower
TRSA *
Unicom
FLIGHT MANAGEMENT
149