Garmin G1000 NXi Pilot's Manual page 440

APPENDIX A
Message
NAV1 MANIFEST – NAV1 software
mismatch, communication halted.
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
NAV2 MANIFEST – NAV2 software
mismatch, communication halted.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NON-MAGNETIC UNITS – Non-
magnetic NAV ANGLE display units
are active.
NON WGS84 WPT – Do not use GPS
for navigation to [xxxx]
PFD1 BACKLIGHT CALIBRATION –
PFD1 calibration lost. Return for repair.
PFD1 CONFIG – PFD1 config error.
Config service req'd.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
PFD1 DB ERR – PFD1 basemap
database error exists.
PFD1 DB ERR – PFD1 multiple
database errors exists.
PFD1 DB ERR – PFD1
navigation database error exists.
PFD1 DB ERR – PFD1 obstacle
database missing.
PFD1 DB ERR – PFD1 Safe Taxi
database error exists.
PFD1 DB ERR – PFD1 terrain
database error exists.
PFD1 DB ERR – PFD1 terrain
database missing.
426
Comments
NAV1 software mismatch. The system should be serviced.
The remote NAV1 transfer switch is stuck in the enabled (or "pressed") state. Press
the transfer switch again to cycle its operation. If the problem persists, the system
should be serviced.
A failure has been detected in the NAV1 receiver. The receiver may still be available.
The system should be serviced.
NAV2 software mismatch. The system should be serviced.
The remote NAV2 transfer switch is stuck in the enabled (or "pressed") state. Press
the transfer switch again to cycle its operation. If the problem persists, the system
should be serviced.
A failure has been detected in the NAV2 receiver. The receiver may still be available.
The system should be serviced.
Navigation angle is not set to MAGNETIC at power-up.
The position of the selected waypoint [xxxx] is not calculated based on the WGS84
map reference datum and may be positioned in error as displayed. Do not use GPS to
navigate to the selected non-WGS84 waypoint..
The PFD1 backlight calibration cannot be found or is invalid. The system should be
serviced.
The PFD configuration settings do not match backup configuration memory. The
system should be serviced.
The PFD is overheating and is reducing power consumption by dimming the display.
If problem persists, the system should be serviced.
The PFD detected a failure in the basemap database.
The PFD detected a failure in more than one database. If problem persists, the system
should be serviced.
The PFD detected a failure in the navigation database. Attempt to reload the
navigation database. If problem persists, the system should be serviced.
The obstacle database is present on another LRU, but is missing on the specified LRU.
The PFD detected a failure in the Safe Taxi database. Ensure that the data card is
properly inserted. Replace data card. If problem persists, the system should be
serviced.
The PFD detected a failure in the terrain database. Ensure that the terrain card is
properly inserted in display. Replace terrain card. If problem persists, the system
should be serviced.
The terrain database is present on another LRU, but is missing on the specified LRU.
Garmin G1000 NXi Pilot's Guide for the Cessna Nav III 190-02177-00 Rev. A