Garmin G1000 NXi Pilot's Manual page 335

The Navigation Map Page Setup Menu also controls the display of traffic. The setup menu controls the map
range settings. Traffic data symbols and labels can be decluttered from the display. If a map range larger than
the map range setting is selected, the data is removed from the map. Maps besides the Traffic Map Page use
settings based on those selected for the Navigation Map Page.
A traffic-only inset map is available on the PFD by pressing the TFC Map Softkey. A traffic map appears on
the PFD. This map resembles the Traffic Map Page, and presents a heading up format. Traffic information
can also be overlaid on PFD navigation maps.
Enabling/disabling traffic overlay on PFD navigation maps:
1) With the Inset Map or HSI Map displayed, press the Map/HSI Softkey on the PFD.
2) Press the Traffic Softkey to enable/disable the display traffic information.
SYSTEM STATUS
The traffic mode is annunciated in the upper right corner of the Traffic Map Page.
Traffic System Test
Initiated
Operating
Standby
Traffic System Failed*
* See Table 6-23 for additional failure annunciations
If the traffic unit fails, an annunciation as to the cause of the failure is shown in the center of the Traffic Map
Page. During a failure condition, the Operating Mode cannot be selected.
Traffic Map Page Center
Annunciation
NO DATA
DATA FAILED
FAILED
190-02177-00 Rev. A
Traffic Mode Annunciation
Mode
(Traffic Map Page)
('TEST MODE' shown in center of page)
(also shown in white in center of page)
Table 6-22 Traffic Modes
Data is not being received from the TAS unit
Data is being received from the TAS unit, but the unit is self-reporting a failure
Incorrect data format received from the TAS unit
Table 6-23 TAS Failure Annunciations
Garmin G1000 NXi Pilot's Guide for the Cessna Nav III
TEST
OPERATING
STANDBY
FAIL
Description
HAZARD AVOIDANCE
Traffic Display Status Icon
(Other Maps)
321