Garmin G1000 NXi Pilot's Manual page 187

VNV Constraints
- Altitude at Arrival
- Along Track Offset
Activation Command
Any waypoint can be entered as a direct-to destination from the Direct-to Window.
Entering a waypoint identifier, facility name, or city as a direct-to destination:
1) Press the Direct-to Key. The Direct-to Window is displayed (with the active flight plan waypoint as the default
selection or a blank waypoint field if no flight plan is active).
2) Turn the small FMS Knob clockwise to begin entering a waypoint identifier (turning it counter-clockwise brings
up the waypoint selection submenu - press the CLR Key to remove it), or turn the large FMS Knob to select the
facility name, or city field and turn the small FMS Knob to begin entering a facility name or city. If duplicate
entries exist for the entered facility or city name, additional entries can be viewed by turning the small FMS
Knob during the selection process.
3) Press the ENT Key. The 'Activate?' field is highlighted.
4) Press the ENT Key to activate the direct-to.
Any waypoint contained in the active flight plan can be selected as a direct-to waypoint from the Direct-to
Window, the Active Flight Plan Page, or the Active Flight Plan Window.
190-02177-00 Rev. A
Figure 5-45 Direct-to Window - PFD
Figure 5-46 Waypoint Submenu
Garmin G1000 NXi Pilot's Guide for Cessna Nav III
FLIGHT MANAGEMENT
Direct-to Point Info
- Identifier/Symbol/City
- Facility Name
Direct-to Point Info
- Bearing/Distance
- Desired Course
Waypoint Submenu
- Flight Plan Waypoints
- Nearest Airports
- Recent Waypoints
- User Waypoints
173