Garmin G1000 NXi Pilot's Manual page 239

Loading an approach into the active flight plan from the Nearest Airport Page:
1) Select the Nearest Airports Page.
2) Press the FMS Knob, then turn the large FMS Knob to highlight the desired nearest airport. The airport is
previewed on the map.
3) Press the APR Softkey; or press the MENU Key, highlight 'Select Approach Window', and press the ENT Key.
4) Turn the FMS Knob to highlight the desired approach.
5) Press the LD APR Softkey; or press the MENU Key, highlight 'Load Approach', and press the ENT Key. The
Approach Loading Page is displayed with the transitions field highlighted.
6) Turn the FMS Knob to highlight the desired transition, and press the ENT Key.
7) Minimums
a) To set 'Minimums', turn the small FMS Knob to select 'BARO' or 'TEMP COMP', and press the ENT Key.
Turn the small FMS Knob to select the altitude, and press the ENT Key.
b) If 'TEMP COMP' was selected, the cursor moves to the temperature field. Turn the small FMS Knob to
select the temperature, and press the ENT Key.
Or :
To skip setting minimums, press the ENT Key. The 'LOAD?' field is highlighted.
8) Press the ENT Key with 'LOAD?' highlighted to load the approach procedure; or turn the large FMS Knob to
highlight 'ACTIVATE' and press the ENT Key to load and activate the approach procedure. The system continues
navigating the current flight plan until the approach is activated. When GPS is not approved for the selected
final approach course, the message 'NOT APPROVED FOR GPS' is displayed. GPS provides guidance to the
approach, but the HSI must to be switched to a NAV receiver to fly the final course of the approach.
ACTIVATING AN APPROACH
A previously loaded approach can be activated from the Procedures Window.
Activating a previously loaded approach:
1) Press the PROC Key. The Procedures Window is displayed with 'Activate Approach' highlighted.
2) Press the ENT Key to activate the approach.
In many cases, it may be easiest to "load" the full approach while still some distance away, enroute to the
destination airport. Later, if vectored to final, use the steps below to select 'Activate Vector-To-Final' — which
makes the inbound course to the FAF waypoint active.
Activating a previously loaded approach with vectors to final:
1) Press the PROC Key to display the Procedures Window.
2) Highlight 'Activate Vector-to-Final' and press the ENT Key.
190-02177-00 Rev. A
Garmin G1000 NXi Pilot's Guide for Cessna Nav III
FLIGHT MANAGEMENT
225