The Restart Softkey is enabled only when the aircraft is on the ground.
NOTE:
9) Select the Restart softkey to restart the system and load the updated database(s), or remove power from the
system if the Restart Softkey is diminished .
10) After restarting the system, turn the large FMS Knob and select the Aux page group on the MFD.
11) Turn the small FMS Knob and select the Databases page.
12) Verify that the standby databases transferred and are now in the active database column.
13) To view database information for an individual display, press and then turn the FMS Knob to select the database,
and then press the Details Softkey. Press the ENT Key or the FMS Knob to exit.
190-02177-00 Rev. A
Figure B-8 Database Expired
Figure B-9 Database Page with Updated Databases
Garmin G1000 NXi Pilot's Guide for the Cessna Nav III
APPENDIX B
437