Garmin G1000 NXi Pilot's Manual page 452

APPENDIX B
14) To manually activate any databases that did not transfer to the active column:
a) Press the FMS Knob. The first database title on the screen will be selected.
b) Turn the small FMS Knob as necessary to select the database title.
c) Press the ENT Key. A cyan double-sided arrow will appear indicating that the standby database will become
active.
d) Remove and reapply power to the system.
e) Verify that the standby databases transferred and are now in the active database column.
15) Remove power from the system.
Updating Databases from the Aux - Databases page:
1) With the system OFF, insert the Flight Stream Mutimedia Card in the bottom slot of the MFD.
2) Turn the large FMS Knob to select the Aux page group on the MFD.
3) Turn the small FMS Knob to select the Database page group on the MFD.
4) Press the Device Softkey.
5) The Aux - Databases page will show the databases connected to the mobile device in place of the active
databases on the system. Databases selected to load will be indicated by a cyan arrow.
6) Press the Update softkey. The Flight Stream 510 will enter WI-FI mode.
7) Put the mobile device in WI-FI mode (refer to the Additional Features section).
8) Connect the mobile device to the Flight Stream 510 WI-FI (refer to the Additional Features section).
9) The Database Update status will appear in the Status window at the top of the page.
The Restart Softkey is enabled only when the aircraft is on the ground.
NOTE:
10) Select the Restart softkey to restart the system and load the updated database(s), or remove power from the
system if the Restart Softkey is diminished .
11) After restarting the system, turn the large FMS Knob and select the Aux page group on the MFD.
12) Turn the small FMS Knob and select the Databases page.
13) Verify that the standby databases transferred and are now in the active database column.
438
Figure B-10 Database Page Details
Garmin G1000 NXi Pilot's Guide for the Cessna Nav III 190-02177-00 Rev. A