Garmin G1000 NXi Pilot's Manual page 107

NAV VOL/ID Knob – Controls NAV audio volume level. Press to turn the Morse code identifier audio on
1
and off. Volume level is shown in the NAV frequency field as a percentage.
NAV Frequency Transfer Key – Transfers the standby and active NAV frequencies.
2
NAV Knob – Tunes the standby frequencies for the NAV receiver (large knob for MHz; small knob for kHz).
3
Press to move the frequency selected for tuning (light blue numbers) and the Frequency Transfer Arrow
between NAV1 and NAV2.
NAV Frequency Box – Displays NAV standby and active frequency fields, volume, and station ID. The
4
frequency of the NAV radio selected for navigation is displayed in green.
COM Frequency Box – Displays COM standby and active frequency fields and volume. The selected and
5
decoded COM transceiver frequency is displayed in green.
COM Knob – Tunes the standby frequencies for the COM transceiver (large knob for MHz; small knob for
6
kHz). Press to move the frequency selected for tuning (light blue numbers) and the Frequency Transfer
Arrow between COM1 and COM2.
COM Frequency Transfer Key – Transfers the standby and active COM frequencies. Press and hold this key
7
for two seconds to tune the emergency frequency (121.500 MHz) automatically into the active frequency
field.
COM VOL/SQ Knob – Controls COM audio volume level. Press to turn the COM automatic squelch on
8
and off. Volume level is shown in the COM frequency field as a percentage.
DME Tuning Window – Displays DME frequency pairing mode. Display by selecting the DME Softkey.
9
ENT Key – Validates or confirms DME pairing mode and Auto-tune selection.
10
FMS Knob – Flight Management System Knob, used to enter transponder codes, select DME modes, and
11
Auto-tune entries when DME Tuning Window or NRST Window is present. Press the FMS Knob to turn
the selection cursor on and off. The large knob moves the cursor in the window. The small knob selects
individual characters for the highlighted cursor location.
Transponder Data Box – Indicates the selected transponder code, operating mode, reply, and ident status
12
for the applicable transponder.
DME Softkey – Displays the DME Tuning Window.
13
190-02177-00 Rev. A
Garmin G1000 NXi Pilot's Guide for the Cessna Nav III
AUDIO PANEL AND CNS
93