Table of Contents
Advertisement
LAG Commands
Lag Data
===============================================================================
Lag-id
-------------------------------------------------------------------------------
1
2
3
4
10
-------------------------------------------------------------------------------
Total Lag-ids: 5
===============================================================================
A:ALA-48>config# show lag
Detailed LAG Output — The following table describes detailed LAG output fields. The output is
dependent on whether or not the LAG was configurd as a multi-chassis LAG.
Detailed LAG Output Fields
LAG ID
Adm
Port Threshold
Thres. Last
Cleared
Dynamic Cost
Configured
Address
Hardware Address
Hold-Time Down
LACP
LACP Transmit
Intvl
Selection Crite-
ria
Number of sub-
groups
System ID
Admin Key
Page 432
Adm
Opr
up
down
up
up
up
down
up
down
up
down
Single Chassis: 2
Label
The LAG or multi-link trunk (MLT) that the port is assigned to.
Up — The LAG is administratively up.
Down — The LAG is administratively down.
If the number of available links is equal or below this number, the
threshold action is executed.
The last time that keepalive stats were cleared.
The OSPF costing of a link aggregation group based on the available
aggregated, operational bandwidth.
The base chassis Ethernet MAC address.
The hardware address.
The timer, in tenths of seconds, which controls the delay between
detecting that a LAG is down and reporting it to the higher levels.
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP timeout signalled to peer.
Configured subgroup selection criteria.
Total subgroups in LAG.
System ID used by actor in LACP messages.
Configured LAG key.
Port-Threshold
Up-Link-Count
0
0
0
1
0
0
0
0
0
0
MC Act: 1
Description
7710 SR OS Interface Configuration Guide
MC Act/Stdby
N/A
active
standby
standby
N/A
MC Stdby: 2
Advertisement
Table of Contents
