Table of Contents
Advertisement
lbo
Syntax
lbo [0dB | -7.5dB | -15.0dB | -22.5dB]
Context
config>port>tdm
Description
This command applies only to a DS-1 port configured with a 'long' buildout (see the buildout command).
Specify the number of decibels the transmission signal decreases over the line.
For 'short' buildout the following values are valid:
lboNotApplicable — Not applicable
For 'long' buildout the following values are valid:
lbo0dB
lboNeg7p5dB
lboNeg15p0dB
lboNeg22p5dB
The default for 'short' build out is 'NotApplicable' while the default for 'long' buildout is 'lbo0dB'.
length
Syntax
length {133 | 266 | 399 | 533 | 655}
Context
config>port>tdm
Description
This command applies only to a DS-1 port configured with a 'short' buildout. The length command
configures the length of the line (in feet). For line lengths longer than 655 feet, configure the DS-1 port
buildout as 'long'.
For 'long' buildout the following values are valid:
NotApplicable — Not applicable
For 'short' buildout the following values are valid:
0 — 133
134 — 266 For line length from 134 to 266 feet
267 — 399 For line length from 267 to 399 feet
400 — 533 For line length from 400 to 533 feet
534 — 655 For line length from 534 to 655 feet
The default for 'long' buildout is 'NotApplicable' while the default for 'short' buildout is '0 — 133'.
7710 SR OS Interface Configuration Guide
For 0 dB
For -7.5 dB
For -15.0 dB
For -22.5 dB
For line length from 0 to 133 feet
Interface Configuration
Page 287
Advertisement
Table of Contents
