Table of Contents
Advertisement
SONET/SDH Path Commands
transparently forwarded. When bcp-null encapsulation is specified, the PPP Bridge Control Protocol
(BCP) is activated and all packets on this access port will be encapsulated in accordance with the BCP
protocol.
Note that null ports will accept q-tagged frames.
bcp-dot1q — Ingress frames carry IEEE 802.1Q tags and the tags are used as service delimiter. Any
untagged packets are silently discarded with exception of protocol specific packets. When bcp-dot1q
encapsulation is specified, the PPP Bridge Control Protocol (BCP) is activated and all packets on this
access port will be encapsulated in accordance with the BCP protocol.
ipcp — Ingress frames are encapsulated according to the IP Control Protocol. When ipcp encapsulation is
specified, the PPP IP Control Protocol will be activated and only packets that comply with IPCP
encapsulation are processed; others are silently discarded.
ppp-auto — Enables PPP on the associated port/channel. The activation of ipcp and mplscp is
automatically enabled depending on the protocol configuration. This encap type is only valid on ports/
channels in network mode.
frame-relay — Enables frame relay on the associated port/channel.
wan-mirror — The port is used for mirroring of frame-relay and POS ports. On these ports, no link
management protocol would run.
cisco-hdlc — Monitors line status on a serial interface by exchanging keepalive request messages with peer
network devices.
ppp
Syntax
ppp
Context
config>port>sonet-sdh>path
Description
This command enables access to the context to configure the LCP operational parameters for a SONET/
SDH Point-to-Point Protocol (PPP) link.
keepalive
Syntax
keepalive time-interval [dropcount count]
no keepalive
Context
config>port>sonet-sdh>path>ppp
Description
This command enables the sending of keepalive messages and configures the time between messages and
how many reports can be missed before bringing the link down.
The no form of this command disables the sending of echo requests.
Default
keepalive 10 dropcount 3
Parameters
time-interval — The time interval, in seconds, that echo requests are issued.
Page 268
7710 SR OS Interface Configuration Guide
Advertisement
Table of Contents
