Table of Contents
Advertisement
TDM Commands
mdl-transmit
Syntax
mdl-transmit {path | idle-signal | test-signal}
no mdl-transmit [path | idle-signal | test-signal]
Context
config>port>tdm>ds3
config>port>tdm>e3
Description
This command enables the transmission of an MDL message on a DS-3/E-3 over channelized interface.
The no form of this command disables transmission of the specified message or all messages.
Default
no mdl-transmit
Parameters
path — Specify the MDL path message.
idle-signal — Specify the MDL idle signal message.
test-signal — Specify the MDL test signal message.
remote-loop-respond
Syntax
[no] remote-loop-respond
Context
config>port>tdm>ds1
Description
When abled, the channel responds to requests for remote loopbacks.
Default
no remote-loop-respond — The port will not respond.
report-alarm
Syntax
[no] report-alarm [ais] [los] [oof] [rai] [looped] [ber-sd] [ber-sf]
Context
config>port>tdm>ds1
config>port>tdm>e1
Description
This command enables logging of DS-1/DS-3 or E-1/E-3 alarms for DS-1/DS-3 or E-1/E-3 ports or
channels.
The no form of this command disables logging of the specified alarms.
Parameters
ais — Reports alarm indication signal errors. When configured, ais alarms are not raised and cleared.
Default
los — Reports loss of signal errors. When configured, los traps are not raised and cleared.
Default
oof — Reports out-of-frame errors. When configured, oof alarms are not raised and cleared.
Default
Page 298
ais alarms are issued
los traps are issued.
oof alarms are not issued.
7710 SR OS Interface Configuration Guide
Advertisement
Table of Contents
