Alcatel-Lucent 7710 SR Configuration Manual page 274

Multilink-Bundle Port Commands
Values
t392dce
Syntax t392dce keepalive
no t392dce
Context config>port>multilink-bundle>mlfr>frame-relay
Description This command configures the DCE keepalive timer value for the LMI.
Parameters keepalive —
equipment.
Values
hello-timeout
Syntax hello-timeout seconds
no hello-timeout
Context config>port>multilink-bundle<mlfr
Description This command specifies the value of the MLFR bundle T_HELLO timer. The timer controls the rate that
hello messages are sent. Following a period of T_HELLO duration, a HELLO message is transmitted onto
the bundle link.
Note that T_HELLO timer is also used during the bundle link add process as an additional delay before
resending an ADD_LINK message to the peer bundle link when the peer bundle link does not answer as
expected.
Default
10 seconds
Parameters
seconds — [1-180 seconds]
ack-timeout
Syntax ack-timeout seconds
no ack-timeout
Context config>port>multilink-bundle>mlfr
Description
This command specifies the value of the MLFR bundle T_ACK timer.
This timer defines the maximum period to wait for a response to any message sent onto the bundle link
before attempting to retransmit a message onto the bundle link.
Default
4 seconds
Parameters
seconds — [1-10 seconds]
Page 248
5 — 30
S
pecify the expected interval in seconds between status inquiries issued by the DTE
5 — 30
7710 SR OS Interface Configuration Guide