Alcatel-Lucent 7710 SR Configuration Manual page 240

Ethernet Port Commands
executed, the default PIR of max is assumed.
Fractional values are not allowed and must be given as a positive integer.
The actual PIR rate is dependent on the queue's adaptation-rule parameters and the actual hardware
where the queue is provisioned.
Values
Default
cir-rate — The cir parameter overrides the default administrative CIR used by the queue. When the rate
command is executed, a CIR setting is optional. When the rate command has not been executed or the
cir parameter is not explicitly specified, the default CIR (0) is assumed.
Fractional values are not allowed and must be given as a positive integer.
Values
Default
scheduler-policy
Syntax scheduler-policy scheduler-policy-name
no scheduler-policy
Context config>port>ethernet>access>egr>qgrp
config>port>ethernet>access>ing>qgrp
config>port>ethernet>network>egr>qgrp
Description
This command associates a virtual scheduler policy with a port queue group. Scheduler policies are defined
in the config>qos>scheduler-policy scheduler-policy-name context.
The no form of this command removes the configured ingress or egress scheduler policy from the queue-
group.
Parameters
scheduler-policy-name — The scheduler-policy-name parameter applies an existing scheduler policy that
was created in the config>qos>scheduler-policy scheduler-policy-name context to create the hierarchy
of ingress or egress virtual schedulers.
exp-secondary-shaper
Syntax exp-secondary-shaper {default | secondary-shaper-name} create
no exp-secondary-shaper secondary-shaper-name
Context config>port>ethernet>egress
Description
This command configures the Ethernet egress expanded secondary shaper on this port.
Parameters
secondary-shaper-name — Specifies the secondary shaper name to apply to this port.
default — Specifies the default secondary shaper to apply to this port.
create — Creates a new secondary shaper for this port.
Page 214
1 — 100000000, max
max
0 — 100000000, max
0
7710 SR OS Interface Configuration Guide