Alcatel-Lucent 7710 SR Configuration Manual page 325

rai — Reports resource availability indicator events. When configured, rai events are not raised and
cleared.
Default
looped — Reports looped packets errors.
looped alarms are not issuedlof — Reports loss of frame errors. When configured, lof traps are not raised
and cleared.
Default
Default
signal-mode
Syntax signal-mode {cas}
no signal-mode
Context config>port>tdm>ds1
config>port>tdm>e1
Description
This command activates the signal mode on the channel. When enabled, it uses routing information to direct
the payload of voice or data to its destination.
The no form of the command reverts to the default value.
Default no signal-mode
Parameters cas — Specifies channel associated signaling.
speed
Syntax speed {56 | 64}
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description
This command sets the speed of the DS-0 channels used in the associated channel-group.
If the higher order channel is a channelized DS-3 then the channels must be DS-1s.
If the higher order channel is a channelized E-3 then the channels must be E-1s.
Default
64
Parameters
56 — Specifies that 56k byte (7-bits per byte) encoding will be used for the associated DS-0 channels.
64 — Specifies that 64k byte (8-bits per byte) encoding will be used for the associated DS-0 channels.
7710 SR OS Interface Configuration Guide
rai alarms are not issued
lof traps are issued
Interface Configuration
Page 299