Table of Contents
Advertisement
Ethernet Port Commands
ingress-rate
Syntax
ingress-rate sub-rate
no ingress-rate
Context
config>port>ethernet
Description
This command configures the maximum amount of ingress bandwidth that this port can receive.
The ingress-rate command is only valid for oversubscribed Ethernet MDAs. See
MDAs on page 20
The no form of this command returns the value to the default.
Default
no ingress-rate
Parameters
sub-rate — The egress rate in mbps.
Values
lacp-tunnel
Syntax
[no] lacp-tunnel
Context
config>port>ethernet
Description
This command enables LACP packet tunneling for the Ethernet port. When tunneling is enabled, the port
will not process any LACP packets but will tunnel them instead. The port cannot be added as a member to a
LAG group.
The no form of the command disables LACP packet tunneling for the Ethernet port.
Default
no lacp-tunnel
load-balancing-algorithm
Syntax
load-balancing-algorithm option
no load-balancing-algorithm
Context
config>port>ethernet
config>port>sonet-sdh>path
config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description
This command specifies the load balancing algorithm to be used on this port.
In the default mode, no load-balancing-algorithm, the port inherits the global settings. The value is not
applicable for ports that do not pass any traffic.
The configuration of load-balancing-algorithm at logical port level has three possible values:
Page 226
for details.
1 — 10000 mbps
7710 SR OS Interface Configuration Guide
Oversubscribed Ethernet
Advertisement
Table of Contents
