Table of Contents
Advertisement
Multilink-Bundle Port Commands
mode
Syntax
mode {dce | dte | bidir}
Context
config>port>multilink-bundle>mlfr>frame-relay
Description
This command configures the DCE/DTE mode of the Frame Relay interface.
Parameters
dce — Enables the DCE mode.
dte — Enables the DTE mode.
bidir — Enables the bidirectional mode for LMI types ANSI and ITU.
n391dte
Syntax
n391dte intervals
no n391dte
Context
config>port>multilink-bundle>mlfr>frame-relay
Description
This command confgures the number of DTE full status polling intervals for the LMI.
Parameters
ntervals — The number of exchanges to be done before requesting a full-status report. A value of 1
specifies to receive full-status messages only.
Values
n392dce
Syntax
n392dce threshold
no n392dce
Context
config>port>multilink-bundle>mlfr>frame-relay
Description
This command configures the DCE error threshold for the LMI.
Default
3
Parameters
threshold — Specify the number of errors that will place the bundle in an operationally down state.
Values
Page 246
1 — 255
1 — 10
7710 SR OS Interface Configuration Guide
Advertisement
Table of Contents
