Table of Contents
Advertisement
t391
Syntax
t391 [5..30]
no t391
Context
config>port>ethernet>elmi
Description
This command configures the polling timer for UNI-C.
Parameters
5 ..30 — Specifies the polling timer for UNI-C.
t392
Syntax
t392 [5..30]
no t392
Context
config>port>ethernet>elmi
Description
This command configures the polling verification timer for UNI-N.
Parameters
5 .. 30 — Specifies the polling verification timer for UNI-N.
mode
Syntax
mode {access | network}
no mode
Context
config>port>ethernet
config>port>sonet-sdh>path
config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description
This command configures an Ethernet port, TDM channel, or SONET/SDH path (sub-port) for access,
network mode operation.
An access port or channel is used for customer facing traffic on which services are configured. A Service
Access Point (SAP) can only be configured on an access port or channel. When a port is configured for
access mode, the appropriate encap-type must be specified to distinguish the services on the port or SONET
path. Once an Ethernet port, a TDM channel or a SONET path has been configured for access mode,
multiple services can be configured on the Ethernet port, a TDM channel or SONET path. Note that ATM,
Frame Relay, and cHDLC port parameters can only be configured in the access mode.
An access port or channel is used for customer facing traffic on which services are configured. A Service
Access Point (SAP) can only be configured on an access port or channel. When a port is configured for
access mode, the appropriate encap-type must be specified to distinguish the services on the port or SONET
path. Once an Ethernet port, a TDM channel or a SONET path has been configured for access mode,
7710 SR OS Interface Configuration Guide
Interface Configuration
Page 191
Advertisement
Table of Contents
