Table of Contents
Advertisement
timeslots
Syntax
timeslots timeslots
no timeslots
Context
config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description
This command defines the list of DS-0 timeslots to be used in the DS-1 or E-1 channel-group. The timeslots
are defaulted as defined below when encap-type is set to/from atm. ATM channel groups do not allow
timeslots to change.
The no form of this command removes DS-0 timeslots from a channel group.
Default
no timeslots — Non-ATM channel groups.1-24 — Channel groups configured under DS-1 with encap set to
ATM.
2-16,18-32 — Channel groups configured under E-1 with encap set to ATM.
Description
timeslots — Specifies the timeslot(s) to be associated with the channel group. The value can consist of a list
of timeslots. Each member of the list can either be a single timeslot or a range of timeslots.
Values
7710 SR OS Interface Configuration Guide
1 — 24 for DS-1 interfaces (the full range is auto-configured for ATM channel groups and
cannot be changed).
2 — 32 for E-1 interfaces (the 2 — 16,18 — 32 ranges are auto-configured for ATM
channel groups and cannot be changed).
Interface Configuration
Page 301
Advertisement
Table of Contents
